We can set up these amps to match your existing
transmitter output. Let us know the output level of your transmitter and
we'll take it from there. These amps were designed to work with our FMS2
exciter which puts out approximately 350 milliwatts. If your transmitter
output is less than this the power output will be reduced unless you
order our pre-driver board. Our pre-driver board will work with a signal
as low as 10 milliwatts and produce the required 350 milliwatts to drive
the output amplifier.
If your transmitter puts out more than this we
simply install a resistive attenuator network to match level
requirements. The input and output connectors on the rear panel are both
BNC unless otherwise requested. Both units require a regulated 12 volt
power supply. The 3 watt unit only needs 1/2 a amp while the 10 watt
unit needs about 2 amps.
